Author
|
Topic: Tsiolkovsky monument model without fins
|
Tallpaul Member Posts: 157 From: Rocky Point, NY, USA Registered: Feb 2012
|
posted 01-31-2020 07:42 AM
I recently purchased a model of the Tsiolkovsky monument that shows Tsiolkovsky standing next to a rocket. When the model arrived I saw that there were slots for fins on the rocket but it did not come with the fins. Does anyone in the cS community have the same model with fins? And, if so, could you post the dimensions of the fins, this will enable me to fabricate the missing fins. The rocket is 13 1/4" long and the slots measure approximately 3 3/8" long. Any assistance would be appreciated. |
OLDIE Member Posts: 271 From: Portsmouth, England Registered: Sep 2004
|
posted 02-02-2020 04:17 AM
I think I have an identical model which I obtained on a visit to the Tsiolkovski museum many years ago. I'll take some photos and measurements and be in touch again soon. |
Tallpaul Member Posts: 157 From: Rocky Point, NY, USA Registered: Feb 2012
|
posted 02-02-2020 08:55 AM
Many thanks. I have ordered the sheet metal so I anxiously await your next message. |
OLDIE Member Posts: 271 From: Portsmouth, England Registered: Sep 2004
|
posted 02-02-2020 09:55 AM
Pics have been sent to your email. Have fun. |
Tallpaul Member Posts: 157 From: Rocky Point, NY, USA Registered: Feb 2012
|
posted 02-02-2020 10:35 AM
Many thanks. Your assistance is one of the reasons why this site is so special. |