Note: Only forum leaders may delete posts.
*HTML is ON *UBB Code is ON Smilies Legend
Smilies Legend
[b]NASA Tests Launch Abort Parachute System[/b] NASA tested the parachutes for the recovery system on its Orion crew exploration vehicle above the U.S. Army's Yuma Proving Grounds in Arizona on July 31. The test proved unsuccessful when a test set-up parachute failed. The failed parachute — called a programmer chute — deployed, but it did not inflate properly and failed to get the test article that simulated the Orion crew module into the correct orientation, altitude and speed for the test, causing the parachute system for the test vehicle to fail. "This is the most complicated parachute test NASA has run since the '60's," said Carol Evans, test manager for the parachute system at NASA's Johnson Space Center in Houston. "We are taking a close look at what caused the set-up chutes to malfunction. A failure of set-up parachutes is actually one of the most common occurrences in this sort of test." To test the first generation design of the recovery parachute system, a mock-up of the Orion crew module was dropped from a C-17 airplane at 25,000 feet altitude. In addition to the parachute system for the mock-up, the test requires 10 parachutes for preparation of the test. Some of these parachutes extract the mock-up from the airplane. Then pyrotechnics fire to separate the mock-up from the pallet on which it sits while inside the plane. As the mock-up is released from the pallet, a programmer chute and two stabilization chutes are released to set up the proper test condition. At a predetermined time, those chutes are released to start the test of the Orion parachute system. The remaining test preparation parachutes return the pallet to the ground. The Orion recovery parachute system is based on the parachute system used for the Apollo capsule and uses eight parachutes. There are three types of parachutes in the parachute assembly system: drogues that are designed to stabilize the spacecraft; pilots which pull out the main parachutes; and mains, which are the large parachutes that actually lower the spacecraft to the ground. The two drogue chutes are deployed to slow the mock-up and ensure it is pointing in the right direction. The drogue chutes are then cut away, and three pilot chutes are deployed and in turn each pull out one of the three main 116-feet-diameter parachutes that will slow the mock-up to a safe landing speed following a launch abort. The pallet has its own parachute recovery system. During the July 31 test, the programmer parachute and the two stabilization chutes released properly. The programmer parachute did not inflate properly, and the stabilization parachutes inflated but did not stay inflated. As a result, the mock-up dropped faster than intended. When the test set-up chutes were released, the drogue chutes were immediately cut away, sending the mock-up into a free fall. During the free fall, the mock-up began to tumble, creating forces that pulled the main parachutes out. Two of the three main parachutes broke free. The third parachute held, but it was torn, too damaged to slow the falling mock-up. The result was a landing that severely damaged the test mock-up. In addition to testing the parachute system, one of the objectives of this test was to demonstrate the testing techniques. NASA engineers and managers are reviewing the test procedures and the test hardware and set-up, along with the video and photographs collected from the test, to determine what caused the programmer chute to fail.
[i]The Orion parachute test vehicle (PTV) is prepared for structural testing in the Structural Test Lab at NASA's Johnson Space Center.[/i]
[i]A test set-up parachute failed during the July 31, 2008, test of parachutes for the recovery system for the Orion Crew Exploration Vehicle. Shown here, the Orion mock-up, attached to a pallet, is pulled from its C-17 transport above the U.S. Army's Yuma Testing Grounds in Arizona.[/i]
[i]As the mock-up is released from the pallet, the programmer chute and two stabilization chutes are released to set up the proper test condition. The programmer chute — the chute that is supposed to get the Orion mock-up in the correct orientation, altitude and speed for the test — failed to inflate properly. The chute was one of 18 parachutes used during the test.[/i]
[i]Only one of the three main parachutes for the recovery system held to the mock-up during the July 31, 2008, test. The parachute was torn and too damaged to inflate properly and slow the falling mock-up.[/i]
[i]The mock-up used during the July 31, 2008, test of the parachute system for the recovery system of the Orion spacecraft was severely damaged when a test set-up chute failed to properly inflate and caused the parachute system to fail. The failed parachute —called a programmer chute — was supposed to get the test vehicle set up to the correct test conditions.[/i]
Contact Us | The Source for Space History & Artifacts
Copyright 1999-2024 collectSPACE. All rights reserved.